UL 1973：2022 major modifications
UL 1973：2022 major modifications,
UL 1973,
▍BSMI Introduction Introduction of BSMI certification
BSMI is short for Bureau of Standards, Metrology and Inspection, established in 1930 and called National Metrology Bureau at that time. It is the supreme inspection organization in Republic of China in charge of the work on national standards, metrology and product inspection etc. The inspection standards of electrical appliances in Taiwan are enacted by BSMI. Products are authorized to use BSMI marking on the conditions that they are in compliance with safety requirements, EMC testing and other related tests.
Electrical appliances and electronic products are tested according to the following three schemes: type-approved (T), registration of product certification(R) and declaration of conformity (D).
▍What is the standard of BSMI?
On 20 November 2013, it is announced by BSMI that from 1st, May 2014, 3C secondary lithium cell/battery, secondary lithium power bank and 3C battery charger are not permitted to access to Taiwan market until they are inspected and qualified according to the relevant standards (as shown in table below).
|
Product Category for Test |
3C Secondary Lithium Battery with single cell or pack ( button shape excluded) |
3C Secondary Lithium Power Bank |
3C Battery Charger |
Remarks: CNS 15364 1999 version is valid to 30 April 2014. Cell, battery and Mobile only conduct capacity test by CNS14857-2 (2002 version).
|
|
Test Standard |
CNS 15364 (1999 version) CNS 15364 (2002 version ) CNS 14587-2 (2002 version)
|
CNS 15364 (1999 version) CNS 15364 (2002 version ) CNS 14336-1 (1999 version） CNS 13438 (1995 version) CNS 14857-2 (2002 version)
|
CNS 14336-1 (1999 version) CNS 134408 (1993 version) CNS 13438 (1995 version)
|
|
|
Inspection Model |
RPC Model II and Model III |
RPC Model II and Model III |
RPC Model II and Model III |
▍Why MCM?
● In 2014, rechargeable lithium battery became mandatory in Taiwan, and MCM began to provide the latest information about BSMI certification and the testing service for global clients, especially those from mainland China.
● High Rate of Pass: MCM has already help clients to obtained more than 1,000 BSMI certificates till now in one go.
● Bundled services: MCM helps clients successfully enter multiple markets in worldwide through one-stop bundled service of simple procedure.
Certification of electric vehicle batteries/storage batteries
The preparation of new site and equipment is to perform more comprehensive services. We are expanding our business and get deep into international certification with TUV RH of storage batteries and electric two-wheel vehicles batteries. Meanwhile we cooperate with EPRI in power grid storage. We will be able to test products of more elaborated design. We will also start projects of certification in transport area, and coordinate with CAAC to gain more resources of air transport.
UL 1973：2022 was published on 25th February. This version is based on two suggestion draft issued in May and October of 2021. The modified standard expands its range, including vehicle assistant energy system (e.g. illumination and communication).
Append 18 Overload Under Discharge: Evaluate battery system ability with overload under discharge. There are two conditions for the test: first is in overload under discharge in which current is higher than rated maximum discharging current but lower than current of BMS overcurrent protection; the second is higher than BMS over current protection but lower than level 1 protection current.
